The Udder Hair Remover works with a cool flame, reaching 300ºC, compared to 1000ºC produced by a gas burner.

It offers a quick and painless way to remove unwanted udder hair. This helps prevent manure, dirt and bacteria from accumulating on the udder which may cause mastitis and Johne’s Disease in calves.

Following use we recommend the use of Dairy Ointment also on the website.

The udder hair remover offers a quick and painless way to remove unwanted udder hair. This helps prevent manure, dirt and bacteria from
accumulating on the udder, that may cause mastitis and Johne’s Disease in calves.
The Udder Hair Remover works with a cool wave flame, which used in a continuous figure of 8 movement, removes excess hair from the udder without
causing pain to the cow. Without hair the udder is less likely to retain dirt and bacteria, which dramatically reduces pre milking preparation time, helps reduce
bacteria around the udder and raise milk quality.
The “cool” flame produced by the Dairy Spares udder hair remover is generated by burning propane with reduced
aeration. This provides a controlled flame reaching about 300° C, which in comparison to the 1000° C and above
produced by a gas burner, allows the cow to perceive the hair removal process as a pleasantly warm procedure that takes only
2-4 seconds.
Dried on dirt sticking to udder hair is not easily removed, even when using water or udder wipes. The “cool” flame leaves the
udder clinically clean and destroys bacteria situated in the dirt accumulated on the udder, improving udder hygiene, considerably
reducing the risk of mastitis and promoting improved milk standards.
The Udder Hair Remover comes complete with adjustable propane regulator and gauge, 3meters of high pressure gas tubing,
flow control hand valve and angled lance to make flame clipping while staying at the back of the cow.